Hitching up the caravan
694 570_b 33
Working steps
1. Manoeuvre your caravan over the tow hitch of your towing vehicle.
2. Hitch up the caravan correctly.
3. Apply the caravan's handbrake.
CAUTION!
The caravan may make a slight rocking movement when the drives are retracted, de-
pending on the last manoeuvre and the resulting stresses in the axles.
Do not park the caravan with its axles stressed/locked up.
➯
After performing tight cornering manoeuvres or pivoting on the spot, move the ca-
ravan in a straight line forwards or backwards for at least 1 metre.
4. Then move the drives away from the wheels.
Make sure there is a gap of at least 20 mm between the drive and the wheel.
ADVICE
If the distance is smaller and/or the drives do not move away from the wheels, this means the
drives must be moved away manually (fig. 8).
5. Check whether all drives are correctly retracted.
6. Release your caravan's handbrake before driving off.
TROUBLESHOOTING
Malfunction Possible cause Solution
Batteries flat Renew the batteries of the re-
mote control
The remote control does not
perform an LED test when swit-
ched on
Remote control defective Renew the remote control and
repeat the teach-in
Supply battery for the drives is
flat, defective, not connected
Check the battery, charge, re-
new or connect it up as requi-
red
Fuse removed or defective Check the fuse
Remote control defective Check the battery/remote con-
trol, renew
Initial start-up cannot be perfor-
med
System defective Contact an AL-KO service
centre
No initial start-up performed
Error during initial start-up
No teach-in of new remote con-
trol
Repeat initial start-up
The system does not establish
a radio link (operation LED on
the remote control does not
show continuous green after a
positioning attempt)
Release line defective Fit a new release line. (As a
temporary solution, the release
button on the F-C-A can be
used for releasing the system)
To Next Page
Loading...
