3. Activate the WPS mode on the router. The camera will begin to connect to the wireless network. The LED will be
solid green when the connection is complete.
4. Add the device to the account by selecting the account in the Partner MobileTech app, by using the Alarm.com
app Video Installation Wizard, or by using a web browser and entering the following web
address: www.alarm.com/addcamera.
Note: You will need the customer’s user name and password if using the Alarm.com customer website or
Alarm.com app.
5. Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s
MAC address is located on the bottom of the camera or on the packaging.
6. Follow the on-screen instructions to finish adding the camera.
You may configure camera settings from the Customer Website. You can now power down the camera and install it in
its final location using the included hardware.
Ethernet mode
Complete these steps prior to installing the camera in its final location.
1. Using an Ethernet cable, connect the camera to the network.
2. Connect the camera’s AC power adapter and plug it into a non-switched outlet.
3. Wait a few minutes for the camera to connect to the Internet. When the LED is solid green, the connection is
complete. If the LED is not solid green after a few minutes:
◦ Power cycle the camera.
◦ Try a different Ethernet port on the router.
◦ Try to connect using a different mode (AP or WPS mode).
4. Add the device to the account by selecting the account in the Partner MobileTech app, by using the Alarm.com
app Video Installation Wizard, or by using a web browser and entering the following web
address: www.alarm.com/addcamera.
Note: You will need the customer’s user name and password if using the Alarm.com customer website or
Alarm.com app.
5. Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s
MAC address is located on the bottom of the camera or on the packaging.
6. Follow the on-screen instructions to finish adding the camera.
Important: If the video device will be connected to the Wi-Fi network after this initial installation, be sure to configure
the Wi-Fi network after the camera is added to the account. For more information about configuring a video device's
wireless settings, see Change a video device's wireless network settings.
You may configure camera settings from the Alarm.com customer website. You can now power down the camera and
install it in its final location using the included hardware.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/1080p_Indoor_Wi-Fi_Camera_ADC-V52…
Updated: Tue, 08 Oct 2024 16:21:33 GMT
5
To Next Page
Loading...
