Now you can use your primary login to access your Wellcam account.
To switch between linked systems, tap the navigation icon, tap your
system’s name, and select the other system you wish to access.
The Linked Systems feature is only enabled for logins that perform
this setup process. Other logins on your primary account will not be
automatically linked to the Wellcam account. For each login you
wish to associate, log in with that login’s password and perform the
setup process outlined in this guide.
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
FCC Caution: Any changes or
modifications not expressly approved
by the party responsible for compliance
could void the user’s authority to
operate this equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation. This device and its
antenna(s) must not be co-located or
operating in conjunction with any other
antenna or transmitter.
For product available in the USA/Canada
market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device is restricted to indoor use.
FCC radiation exposure statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum
distance 20cm between the radiator
& your body.
IC statement
This device complies with Industry Canada’s
licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device
may not cause interference; and (2) This
device must accept any interference,
including interference that may cause
undesired operation of the device.
continued
14 15
Notices
Federal Communication Commission
interference statement
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures: