45
7. Sleep mode
- If the ECS remote control is not used for more than 20 seconds
after an operation step, it automatically switches to the so-called
„sleep mode“ in order to conserve the internal batteries. However,
this has no inuence on the function of the e-motion wheels.
- Sleep mode is indicated by the following symbol on the ECS
remote control display [2]:
- In addition, the last activated assistance level and – if activated –
the symbol for the rollback delay are shown in the LCD of the
ECS remote control [2].
- The ECS remote control cannot be operated in sleep mode. The
e-motion itself can continue to be used in the usual way.
- To activate the ECS remote control again, press the on/off button
for approx. one second.
- The ashing Bluetooth symbol is now shown until a connection
to the e-motion wheels has been established again. Afterwards,
To Next Page
Loading...