97
EXTENDING EXISTING INSTALLATIONS
EXTENDING THE NUMBER OF MONITORS IN INSTALLATIONS
6+N+COAXIAL SYSTEM
Use
It is possible to extend the installation in a house or flat
by adding more monitors, until a maximum of 4. Each
monitor will have the same functions as the original moni-
tor: auto switch-on, reception of calls, viewing of image
on screen, communication with the entrance panel and
door opening.
Considerations
The ALM power supply unit can feed up to 2 monitors.
An additional power supply unit will be required when
installing 3 or 4 monitors.
EXTENDING A SYSTEM WITH ONE ADDITIONAL MONITOR
SINGLE WIRED DIAGRAM
MVB-001
+
SCM-010
2
ALM-040
5
2
2
1
230 V
V
First monitorSecond monitor
5
COAXIAL
MVB-001
+
SCM-010
2
ALM-040
5
2
2
1
230 V
V
5
COAXIAL
DIV-024
Installation with tap-off Installation without tap-off
First monitorSecond monitor
Operation
The electronic call signal is common for all the moni-
tors. The call is distributed to all the monitors so its volu-
me is correspondingly reduced. The consumption of the
installation is higher as it is necessary to increase the sec-
tion of the cables that must be used. Up to 4 monitors
can be installed following the indications regarding the
different sections contained in this manual.
To Next Page
Loading...
