Alcatel-Lucent 7210 SAS - Page 44

Show Commands
Page 44 7210 SAS D, E OS Router Configuration Guide
-------------------------------------------------------------------------------
10.20.1.24 00:16:4d:23:91:b8 00h00m00s Oth system
10.10.4.11 00:03:fa:00:d0:c9 00h57m03s Dyn[I] to-core-sr1
10.10.4.24 00:03:fa:41:8d:20 00h00m00s Oth[I] to-core-sr1
-------------------------------------------------------------------------------
No. of ARP Entries: 3
===============================================================================
fib
Syntax
Context show>router
Description This command displays the active FIB entries for a specific .
Parameters ip-prefix/prefix-length — Displays FIB entries only matching the specified ip-prefix and length.
Values ipv4-prefix: a.b.c.d (host bits must be 0)
ipv4-prefix-length: 0 — 32
longer — Displays FIB entries matching the ip-prefix/mask and routes with longer masks.
interface
Syntax interface [{[ip-address | ip-int-name] [detail]}
Context show>router
Description This command displays the router IP interface table sorted by interface index.
Parameters ip-address — Only displays the interface information associated with the specified IP address.
Values ipv4-address a.b.c.d (host bits must be 0)
ip-int-name — Only displays the interface information associated with the specified IP interface name.
detail — Displays detailed IP interface information.
Output Standard IP Interface Output — The following table describes the standard output fields for an IP
interface.
Label Description
Interface-Name
The IP interface name.
Type
n/a — No IP address has been assigned to the IP interface, so the IP
address type is not applicable.
Pri — The IP address for the IP interface is the Primary address on
the IP interface.