Page 120 7450 ESS OS Basic System Configuration Guide
site customer-site-name — Specify the customer site which is an anchor point for ingress and egress virtual
scheduler hierarchy.
scheduler scheduler-name — Specify an existing scheduler-name. Scheduler names are configured in the
config>qos>scheduler-policy>tier level context.
Values An existing scheduler-name is in the form of a string up to 32 characters long composed
of printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
ingress — Displays the customer’s multi-service-site ingress scheduler policy.
egress — Displays the customer’s multi-service-site egress scheduler policy.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
sap
Syntax sap sap-id [scheduler scheduler-name] [ingress | egress] [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>qos>scheduler-stats
Description Use this command to monitor scheduler statistics for a SAP at the configured interval until the configured
count is reached.
The first screen displays the current statistics related to the specified SAP. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
scheduler scheduler-name — Specify an existing scheduler-name. Scheduler names are configured in the
config>qos>scheduler-policy>tier level context.
Values An existing scheduler-name in the form of a string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
To Next Page
Loading...
