Alcatel-Lucent 7450 ESS-12 - Displaying Directory and File Information

Page 68 7450 ESS OS Basic System Configuration Guide
Displaying Directory and File Information
Use the dir command to display a list of files on a file system.
The type command displays the contents of a file.
The version command displays the version of a *.tim file
Use the CLI syntax displayed below to display directory and file information:
CLI Syntax: file>
dir [file-url]
type file-url
version file-url
The following displays an example of the command syntax:
ALA-1>file cf1:\ # dir
Volume in drive cf1 on slot A has no label.
Directory of cf1:\
01/01/1980 12:00a 7597 fred.cfg
01/01/1980 12:00a 957 b.
08/19/2001 02:14p 230110 BOOTROM.SYS
01/01/1980 12:00a 133 NVRAM.DAT
04/03/2003 05:32a 1709 103.ndx
01/28/2003 05:06a 1341 103.cftg.ndx
01/28/2003 05:06a 20754 103.cftg
04/05/2003 02:20a <DIR> test
15 File(s) 338240 bytes.
3 Dir(s) 1097728 bytes free.
ALA-1>file cf1:\ # type fred.cfg
# Saved to /cflash1/fred.cfg
# Generated THU FEB 21 01:30:09 2002 UTC
exit all
config
#------------------------------------------
# Chassis Commands
#------------------------------------------
card 2 card-type faste-tx-32
exit
#------------------------------------------
# Interface Commands
#------------------------------------------
# Physical port configuration
interface faste 2/1
shutdown
mode network
exit
interface faste 2/2
shutdown
exit
interface faste 2/3