Root Commands
7450 ESS OS Basic System Configuration Guide Page 129
===============================================================================
A:ALA-12>monitor>router>ldp#
A:ALA-12>monitor>router>ldp# statistics interval 3 repeat 3 rate
===============================================================================
Monitor statistics for LDP instance
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 1 Serv FECs Recv : 2
-------------------------------------------------------------------------------
At time t = 3 sec (Mode: Rate)
-------------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 0 Serv FECs Recv : 0
-------------------------------------------------------------------------------
At time t = 6 sec (Mode: Rate)
-------------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 0 Serv FECs Recv : 0
-------------------------------------------------------------------------------
At time t = 9 sec (Mode: Rate)
-------------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 0 Serv FECs Recv : 0
===============================================================================
A:ALA-12>monitor>router>ldp#
interface
Syntax interface interface [interface...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>mpls
Description This command displays statistics for MPLS interfaces at the configured interval until the configured count is
reached.
The first screen displays the current statistics related to the MPLS interface(s). The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the keyword rate is
specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters interface — Specify the interface's IP address (ip-address) or interface name (ip-int-name). Up to 5
interfaces can be specified. If the string contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
To Next Page
Loading...
