System Management
7450 ESS OS Basic System Configuration Guide Page 341
After a rising threshold crossing event is generated, another such event will not be generated until the
sampled value falls below this threshold and reaches less than or equal the falling-threshold value.
Default 0
Values -2147483648 — 2147483647
falling-threshold threshold — The falling-threshold specifies a threshold for the sampled statistic. When
the current sampled value is less than or equal to this threshold, and the value at the last sampling
interval was greater than this threshold, a single threshold crossing event will be generated. A single
threshold crossing event will also be generated if the first sample taken is less than or equal to this
threshold and the associated startup-alarm is equal to falling or either.
After a falling threshold crossing event is generated, another such event will not be generated until the
sampled value rises above this threshold and reaches greater than or equal the rising-threshold value.
Default 0
Values -2147483648 — 2147483647
interval seconds — The interval in seconds specifies the polling period over which the data is sampled
and compared with the rising and falling thresholds.
Values 1 — 2147483647
rmon-event-type — Specifies the type of notification action to be taken when this event occurs.
Values log — In the case of log, an entry is made in the RMON-MIB log table for each event
occurrence.
This does not create a TiMOS logger entry. The RMON-MIB log table entries can be
viewed using the show>system>thresholds CLI command.
trap — In the case of trap, a TiMOS logger event is generated. The TiMOS logger utility
then distributes the notification of this event to its configured log destinations which may
be CONSOLE, telnet session , memory log, cflash file, syslog, or SNMP trap destinations
logs.
both — In the case of both, both a entry in the RMON-MIB logTable and a TiMOS logger
event are generated.
none — In the case of none, no action is taken.
Default both
Values log, trap, both, none
startup-alarm alarm-type — Specifies the alarm that may be sent when this alarm is first created. If the
first sample is greater than or equal to the rising threshold value and startup-alarm is equal to rising or
either, then a single rising threshold crossing event is generated. If the first sample is less than or equal
to the falling threshold value and startup-alarm is equal to falling or either, a single falling threshold
crossing event is generated.
Default either
Values rising, falling, either
To Next Page
Loading...
