Page 118 7450 ESS OS Basic System Configuration Guide
arbiter-stats
Syntax arbiter-stats
Context monitor>qos
Description This command enables the context to configure monitor commands for arbiter statistics.
sap
Syntax sap sap-id [arbiter name | root] [ingress | egress] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a SAP.
Parameters sap-id — Specify the physical port identifier portion of the SAP definition.
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing scheduler-name in the form of a string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
root — Specify the scheduler to which this queue would be feeding.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
To Next Page
Loading...
