7.14 Install a jack accessory (headset, handsfree, loudspeaker)
By default, the audio jack of your telephone can be used to connect a headset, hands-free kit or
loudspeaker. A wideband headset can also be installed for optimized sound quality.
When you plug the jack accessory in the jack, a popup asks you for the type of accessory:
Headset
Handset
Handsfree
Loudspeaker
A specific icon is displayed in the status bar: .
If necessary, you can also select the accessory type in the audio settings:
or (long press) Audio.
Jack config.
Headset / Handset / Handsfree / Loudspeaker Select the type of device plugged into the jack.
Your phone is equipped with a 3.5 mm, 4 pole jack. If your device is not compatible, you can use an
adapter.
7.15 Activating/Deactivating 'Forced headset' mode
Reach the 'Menu' page.
Settings Phone ForcedHead
ON/OFF activating/deactivating forced headset.
7.16 Installing a Bluetooth® Wireless Technology handset (pairing)
This feature is only available with compatible Bluetooth® deskphone. Otherwise the corresponding menu
is not displayed or is inactive.
Before a Bluetooth® headset can be used, it must be correctly paired to the terminal.
Use one of the following:
o
o (long press) Bluetooth
Search devices
With the handset turned off, press the 2 Bluetooth® handset keys at the same time (long
press).
You will hear a 3 note signal and the LED will flash green and orange alternately.
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
Select the relevant equipment: ALE BT Handset.
Add
Enter the PIN code of the device if necessary. The default password is 0000.
Confirm The 3-note tone indicates that the handset has been installed correctly. The LED
flashes green or orange depending on the battery charge level.
To Next Page
Loading...
