36
SETTINGS
SETTINGS DURING A CALL
The HEADSET/PA, PHONE BOOK, TRANSFER and EQUALIZER menus may be accessed
during a call and are displayed when the MENU button is pressed. The rst option is either
HEADSET or PA depending on whether PA is enabled or not.
These HEADSET/PA settings can only be accessed when a call is connected.
Turn off the internal speakers when using a headset
PA should not be enabled when using the HEADSET menu option.
A wireless headset can be used if a person needs to move far away from the conference
phone (e.g. during a seminar or presentation). The internal speakers can be turned off tempo-
rarily if you wish to use the Alcatel Lucent 8135S as a personal telephone with a headset.
Select MENU > HEADSET.
Select YES when asked “SPEAKER OFF?”.
The speakers come on automatically when the call is ended.
Adjusting microphone volume from PA
PA should be enabled when using the PA menu option.
Select MENU > PA > PA MONITOR.
Adjust the microphone volume from the mixer so that the level on the display screen is
around 10–12 when speaking in a normal tone.
Adjusting PA calibration manually
It is possible to calibrate the duplex performance of the conference phone when it is con-
nected to a PA system. The calibration level can be set automatically by the Alcatel Lucent
8135S or adjusted manually to any value between 0 and 5 (0 being full duplex).
• Increase the calibration if the other party experiences disturbing echo.
• Decrease the calibration if the other party experiences low duplex, i.e. your voice is
muted or clipped when the other party is speaking.
The position of the PA system’s microphones and speakers and the amplier’s settings
may affect full duplex performance.
To Next Page
Loading...