8AL90323ENAAed01
9.4 Embedded alarms: man down, shock, no movement, pull cord alarms
A sensor is integrated in your handset. Depending of the configuration, an alarm is triggered in the following
situations:
Man Down: the handset detects a loss of user verticality, such as by falling to the ground due to an
injury, and triggers an alarm to the server.
No movement: following a user accident or injury, the Handset detects a period of inactivity of the user
and triggers an alarm to the server.
Shock: the handset detects any abnormal shock and triggers an alarm to the server.
Pull-cord: the handset triggers an alarm (with or without a location audio signal) when the handset is
snatched out of the user hands.
9.5 Forced ring
Your phone may be in silent or vibrate mode. Despite this configuration your phone may ring when there is
a specific call from an alarm server. While the handset is ringing, a message (maximum of 14 characters)
may also appear on the phone display.
9.6 Calls
While the phone is making such a call, the standard call processing message appears on the display and
you are unable to receive or set up any other calls.
Notification calls have the highest priority over any other calls. In the event of a notification call, any other
call will be interrupted. All keys will be locked during the notification process in order to avoid the activation
of call back, consultation call, etc.
9.7 Alarm acknowledgment
After an alarm is triggered, the alarm server can set a location audio signal on the phone. This signal is
designed to help rescue teams to locate the phone and its user.
The phone sends a location audio signal.
If configured. Enter device PIN code (The default is 0000).
The location audio signal ends up.
If the on-screen acknowledgment is configured you can directly acknowledge by pressing on the
acknowledgment softkey when the 'Send Acknowledge' pop-up is displayed.
To Next Page
Loading...
Need help?
General
