Support: UK 0800 1950088 / IRL 1800 719310 Mon to Fri 0900–1730 info@alcosense.co.uk
6
First Time Setup
1. Set the BBR
2. Install the batteries and clean the sensor
3. Set the Drink Drive Alert level
1. Set the BBR
a. The BBR (Blood Breath Ratio) must be set for your country of use.
Please see the table on the inside back cover to find your setting, the
UK and Ireland is 2300:1.
b. Open the battery compartment as shown in figure 1 below and pull
out the strip labelled “PULL OUT BEFORE USE”.
c. There is a small slide switch inside the top left-hand corner of the
battery compartment, highlighted red in figure 2 opposite (please
note the switch is BLACK in real life). Using a pen or other thin
object, slide the switch to correspond with the BBR value for your
country of use as found in the inside back cover of this manual. If you
have any difficulties, feel free to call us.
Figure 1
To Next Page
Loading...
