ALDI 1956 - Assembly; Fitting and Removing the Battery Pack, and Battery Charging

16V Lithium-ion Cordless Drill
AFTER SALES SUPPORT
(toll free)MODEL No.: CDT214XA • 05/2019 • 1956
e-mail: info.aldi@positecgroup.com
AUS
14
1300 889 028
AUS
Assembly
Assembly
Fitting and removing the battery pack, and battery charging
IMPORTANT. Before attempting to charge the battery, check the battery
charger (10) to ensure it matches the battery supplied.
Only use the provided battery charger for use with the batteries supplied.
Do not use any other charger. Using other chargers will damage the batteries.
CAUTION! The battery (8) may require charging at rst use. A full charge will
require approximately 1 hour, or until fully charged as indicated by the green
light on the battery charger (10).
CAUTION! The working temperature of the charging operation is 0°C to 40°C.
WARNING: When the battery charge runs out after continuous use or
exposure to direct sunglight or heat, allow time for the battery to cool
down before re-charging to achieve full charge.
1. Connect the battery (8) to the drill by aligning the guiding rails on the
bottom of the drill body with those on the battery (8). A “click” will indicate
the battery is secured to the drill body (Fig A).
2. To disconnect the battery (8), click on the battery release tab (9) and pull the
battery (8) forwards towards the front of the drill.
3. To start the charging process, connect the battery charger (10) in to a 240V
mains power outlet (Fig B).
4. Connect the battery charger (10) lead in to battery charger port (12) (Fig C).
A. B. C.
“CLICK”