16V Lithium-ion Cordless Drill
AFTER SALES SUPPORT
(toll free)MODEL No.: CDT214XA • 05/2019 • 1956
e-mail: info.aldi@positecgroup.com
AUS
16
1300 889 028
AUS
H.
G.
CAUTION. Extended use of the variable speed under load will overload and then
permanently damage the speed control.
Drill/driver Overload
This drill/driver is tted with an overload protection. If the drill/driver is excessively
forced, or the task being performed is too great for the drill/ driver, the drill/driver will
automatically go into an overload mode. When the drill/driver goes into overload, the
drill/driver will automatically and suddenly STOP. To reset the overload, simply release
the trigger. When the trigger is pressed again, the drill/driver will restart. Resume work
after the overload has been reset, but reduce the load by using a smaller drill/driver
bit or re-sharpen the existing drill/driver bit and reduce the amount of force placed
on the drill/driver. If the drill/driver is set to High speed on the gear selector, consider
changing to low speed selection.
Operation
Using the drill/driver
Trigger switch
1. Use the forward/reverse switch (5) to select the
direction of rotation (Fig G), then pull the trigger (7)
(Fig H). This trigger switch is an electronic variable
speed control which enables the user to vary the
speed continuously.
The speed varies according to how far the trigger
switch is depressed.
The further it is depressed the faster the chuck will
rotate and the lighter it is depressed, the slower it
will rotate.
2. To stop the drill/driver, release the trigger switch (7).
NOTE: The variable speed control tted to this drill/
driver is NOT intended to be used for long periods
of time during the operation of the task being
performed. Use the variable speed to start drill/
driving and screwing tasks, and then fully depress
the trigger once the task has started.
To Next Page
Loading...
