ALDI 1956 - Page 27

16V Lithium-ion Cordless Drill
AFTER SALES SUPPORT
(toll free) MODEL No.: CDT214XA • 05/2019 • 1956
e-mail: info.aldi@positecgroup.com
AUS
25
1300 889 028
AUS
Trouble Shooting Specications
How do I adjust the torque?
To adjust the torque setting you rotate the torque collar (2). The higher the number, the higher
the torque setting collar.
Controlling the torque allows for better control when using the drill/driver on specic add
screwing tasks and assists in preventing over-fastening and over-tightening.
For setting the torque position, rst select a low setting on the torque collar (2) and align the
selected symbol with the triangular indicator on the top of the drill/driver.
Slowly increase the torque setting to the desired level. It is suggested to test the setting on scrap
material rst.
How do I select drill function?
When using the drilling function the torque control has no eect to the output of the drill. The
drill function is used when using the drill to drill holes in metal, non ferrous material, wood, plastic
and similar materials. Rotate the function selection collar so the symbol of the drill bit aligns with
the triangular indicator on the top of the drill housing.
What is the function of the Forward / Reverse switch?
This switch (5) will allow you to change the direction of the motor while the trigger switch is not
depressed.
Drill/driving uses the forward mode. The reverse mode is intended for the removal of screws and
assisting to remove jammed drill/driver bits.
What do I do if I have an issue with my drill?
If you have any issues with your drill/driver, please contact our Customer Service line on
1300 889 028.