16 17
Increasing the thread from
¾“ BSP to 1” BSP:
Or to any other larger threads, you
need to purchase a ¾” BSP male
increasing nipple. The nipple needs
to have a male ¾” BSP thread so it
will enter the tting supplied with
the pump but the other end can be
either male or female, depending
on the application you require.
You can continue to add further
adaptors to increase the thread size.
Fig K is a basic guide. The nal
ttings you purchase will depend
on the connection to your
application.
K.
3/4” BSP threaded
outlet adaptor (11)
(supplied)
OR
*
*
*
*
*
OR
Male
Increasing nipple
3/4” BSP
* Additional ttings NOT supplied with this garden pump. * Additional ttings NOT supplied with this garden pump.
Fitting and using the supplied 19mm straight hose outlet
adaptor (10).
(The following details are a guide to the pressure outlet (5) applications)
1. This tting is used where the pump will be tted to a 19mm poly pipe in a
vertical direction. Remove the protective cover on the thread of the outlet
of the pump.
2. Making sure the “O” ring is tted to the shoulder of the outlet tting,
thread the tting into the outlet of the pump sucient to compress the
“O” ring rmly (Fig M).
NOTE: Teon tape is NOT required on the thread.
3. Fit a clamp onto the poly pipe hose and push the hose fully over the
spigot of the outlet tting.
4. Reposition the hose clamp over the length of pipe over the tting and
tighten securely.
Decreasing the thread from
¾” BSP to a smaller thread
type:
ie. ½” BSP, you need to purchase a
reducing nipple. Again, the nipple
must have a male ¾” BSP thread so it
will enter the adaptor supplied with
the pump. On the other end it can
be either a male or female thread.
The pic shows the nipple with a
female thread to accept smaller
ttings as shown in Fig L.
L.
3/4” BSP
threaded
outlet adaptor
(11) (supplied)
1/2” BSP
3/4” to 1/2”
BSP reducer
3/4” BSP
*
*
M.
O Ring
19mm straight
hose outlet
adaptor (10)
(supplied)
To Next Page
Loading...
