ALDI 44268 - 3;4 BSP Adaptor and Hose Fitting; Using 3;4 BSP Adaptor; Pressure Line Connections Guide

1100W Garden Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. XKJ-1109PE • 1/2018 • 44268
(toll free)
AFTER SALES SUPPORT
(toll free)
1100W Garden Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. XKJ-1109PE • 1/2018 • 44268
18 19
P.
3/4” BSP
Elbow Adaptor* Fitting
3/4” BSP threaded
outlet adaptor
(11) (supplied)
*
*
N.
O.
Elbow Adaptor*
3/4” BSP
Fitting
3/4” BSP threaded
outlet adaptor
(11) (supplied)
*
*
O Ring
Adaptors, reducing nipples and elbows
are all available from most hardware /
plumbing stores and starting o with a
¾” BSP male tting will get you started.
The following is a guide for the
use of the adaptor.
• Remove the protective cover on the
thread of the outlet of the pump.
• Making sure the “O” ring is tted to the
shoulder of the outlet tting adaptor,
thread the tting into the outlet of the
pump sucient to compress the “O”
ring rmly (Fig N).
NOTE: Teon tape is NOT required
on the thread of the adaptor into the
pump.
You now need to determine if your
plumbing requirements are ¾“ BSP
or larger.
ALSO NOTE: Teon tape (13) (not
supplied) should be applied to all other
threaded connections on the outlet side
of the adaptor provided.
Using the adaptor with
additional ttings.
Using with pipe work at ¾” BSP. For the ¾“
BSP adaptor outlet, you need to purchase
a ¾” BSP male tting, being either an
elbow or straight nipple so as to enter the
adaptor. The other end of the tting you
purchase will need to match the threaded
pipe you are connecting to (Fig O).
OR you may use a tting to connect
directly to a poly pipe in a horizontal
position (Fig P).
Pressure line connection.
IMPORTANT: ONLY use either of the two adaptors (10 & 11) supplied with
the pump for a pressure line connection.
DO NOT purchase any other tting and attempt to screw directly into the
pump.
Other purchased ttings can ONLY be screwed directly into the 3/4” BSP
threaded outlet adaptor (11) provided.
1. The pressure line* (should be at least 19mm (3/4”)) must be connected
to the pump’s pressure outlet (5) either directly or via a threaded nipple
using the supplied adaptors only.
2. The 19mm straight hose outlet adaptor (10) will accept a 19mm hose. The
threaded 3/4” BSP 20mm threaded outlet adaptor (11) will accept pipe
ttings with a 3/4” BSP (20 mm) thread, either for hard plumbing or hose
applications.
3. A 13 mm (1/2”) pressure hose* can also be used with the appropriate
screw connections, but thiswill only reduce the ow rate.
Fitting and using the supplied 3/4” BSP threaded outlet
adaptor (11).
This tting is used to connect the output of the pump to various hard
plumbed threaded applications or hose tting applications.
The outlet of the adaptor is ¾” BSP. Many variations of threads and ttings
can be purchased from your local hardware / plumbing store to suit the
application required.
* Additional ttings as shown in pictures are NOT supplied with this garden pump.* Additional ttings as shown in pictures are NOT supplied with this garden pump.