10 11
Suitable Applications for intended use of the
1100W Garden Pump
• Irrigation and watering green areas, vegetable beds and gardens.
• Operation of lawn sprinklers.
• For drawing water from ponds, streams, rainwater butts, rainwater
cisterns and springs for supplying service water.
• For pumping of clear water (fresh water), rainwater to your garden and
other non drinking domestic applications, or light suds / service water.
• Domestic rainwater tanks.
Unsuitable Applications for the 1100W Garden Pump
• This garden pump is not designed for, and is not suitable for use in
swimming pools, spa’s or any similar conditions. Do not use in these
applications.
• This is NOT a submersible pump. It should not be immersed in water.
• The pumping of aggressive liquids (acids, alkalis, silo seepage etc) as well
as liquids with abrasive substances (sand), must likewise be avoided.
• Do not use the equipment to pump ammable, gaseous or explosive
uids.
• This garden pump is not designed to transfer drinking water.
• The maximum temperature of the uid must not exceed 35 degrees
celsius if the equipment is being operated permanently.
This equipment is to be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries of any kind
caused as a result of this.
NOTE: Our equipment has not been designed for use in commercial,
trade or industrial applications. Warranty will be voided if the machine
is used in commercial, trade or industrial businesses or for equivalent
purposes.
Connection of the Garden Pump to mains power
WARNING: Do NOT connect the pump to the mains power supply until all
other connections to the water supply are complete and perfectly
sealed (Fig A).
It is recommended that the pump be installed with an approved RCD -
Residual Current Device (not supplied), of 30mA or less (Fig B).
The pump should not be turned on until it is prepared for priming with
water as per the process on page 21/22 is complete.
The pump should only be connected to a 230-240Vac ~ 50Hz power outlet
with a minimum rating of 10 Amps.
B.A.
To Next Page
Loading...
