ALDI 44268 - Mode 1: Automatic and Mode 2: Timed; Mode 1: Automatic Operation; Mode 2: Timed Operation; Setting the Time Function

1100W Garden Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. XKJ-1109PE • 1/2018 • 44268
(toll free)
AFTER SALES SUPPORT
(toll free)
1100W Garden Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. XKJ-1109PE • 1/2018 • 44268
26 27
Mode 2: Timed
This pump uses a 24 hour clock
(morning am - 0-12:00, pm being 12:01 - 24:00)
In this mode, you can set the garden pump to start and nish at particular
times of the day. This mode sets a time for operation of the pump on
consecutive days continuously. The time can only be set for 1 period per
day, which is the same time every day.
To use the time mode, the operator must set the NOW time ( time of the
day) and also the ON and OFF for the pump. When setting the times, if
no entry is made in 10 sec the display will return to thetime modeinitial
screen. Simply start the procedure over if you miss the 10 second limit.
Using and setting the time function
1. To select Timed mode Turn on
Power Press “MODE” button twice.
The Display will now say
”Time Mode” (Fig AL).
The Display will change after
3 seconds to show”TIME NOW”
(Fig AM)
You will now have 10 seconds to
enter your “NOW” time with the
3 buttons now reecting:
Save = “CHECK” ,
Set = “SET”,
Exit = “MODE”
If no entry is made in 10 seconds,
the display will show “Time Mode,
NOT SET” (Fig AL).
AI.
AJ. AK.
Mode 1: Automatic
In this mode the pump will turn o when your tap is turned o and re-start
when the tap is turned back on, hence an automatic operational response.
To select automatic mode, press the “MODE” button once. The screen will
show that you are in automatic mode (Fig AI). 
When the tap is turned on, the screen will show an “L” indicating the pump
is drawing water.
When the tap is closed, the screen will indicate a “P”.
X 1
AL.
AM.
X 2
*AFTER 10 SECONDS