17
Preparatory work
6. Move the bobbin spindle to the left and remove the bobbin.
7. Cut the ends of the thread.
Removing the bobbin case
− Remove the table extension.
− Move the needle
23
to the highest position by turning the
hand wheel
8
and the presser foot and open the bobbin case
behind the accessories box
15
, as shown in the diagram.
− Open the rocking arm of the bobbin case and remove it from
the machine.
− When you let go of the rocking arm, the bobbin will fall out of
the bobbin case automatically.
Threading the bobbin case
− Hold the bobbin between the thumb and index fi nger of your
right hand and leave about 15 cm of the thread hanging out.
− Hold the bobbin case in your left hand and put the bobbin in
the bobbin case.
− Put the end of the thread into the slit on the edge of the bobbin
case.
To Next Page
Loading...
