42
Maintenance and cleaning
Removing and fi tting the presser foot
Removal
− Turn the hand wheel towards you until the needle has reached
its highest position.
− Lift the presser foot
26
by raising the presser foot lever
20
to
the highest position.
− The presser foot will drop out if you push the foot release lever
22
behind the presser foot holder.
Fitting
− Fit the presser foot so that the pin on the foot is directly under
the groove of the foot holder.
− Lower the presser foot lever. The sewing foot will automatically
click into place.
− Now push the sewing foot release lever upwards.
Removing and fi tting the presser foot holder
The presser foot holder does not need to be removed unless you
want to darn or embroider or make space to clean the fabric feeder
25
.
Removal
− Move the needle to its highest position by turning the hand
wheel towards you and raise the presser foot lever.
− Remove the foot from the presser foot holder and, using the
screwdriver provided, undo the presser foot holder screw
27
.
Fitting
− Move the needle to its highest position by turning the hand
wheel towards you and raise the presser foot lever.
− When you attach the presser foot holder, push it upwards as far
as possible and, using the screwdriver provided, tighten the
presser foot holder screw.
To Next Page
Loading...
