45
Maintenance and cleaning
− Refi t the shuttle track ring.
− Turn the snap levers inwards, as shown in the diagram.
− Finally, refi t the bobbin case.
TIP
These parts of the machine may need to be oiled more frequently,
depending on how often you use the machine.
Oiling the machine
The sewing machine is oiled at the factory and delivered
ready for use.
Oiling the machine behind the front fl ap
− Remove the screw cap (A).
− Undo the screw (B) on the front cover.
− Move the front cover (C) to the left and take it off.
− You should clean these areas before oiling them.
The places which need to be oiled are marked with an arrow on the
diagram opposite.
− Put one or two drops of good sewing machine oil on these
areas.
C
B
A
To Next Page
Loading...
