underbucking (2) the lower 2/3 to meet the rst cut.
When bucking on a slope always stand on the uphill side of the log, as
illustrated in Figure 6. When “cutting through”, to maintain complete control
release the cutting pressure near the end of the cut without relaxing your
grip on the chain saw handles. Don’t let the chain contact the ground. After
completing the cut, wait for the saw chain to stop before you move the
chain saw. Always stop the motor before moving from tree to tree.
1
2
1/3
2/3
Fig.5 Fig.6
Residual risk
Even if you use the 2-in-1 Chainsaw with Telescopic Pole properly per the
instructions provided and following all safety notes, there are always
residual risks. The following risk may occur:
- Accidental Starting: Always remove the plug from the socket
before carrying out any adjustment, servicing or maintenance. When
not in use, store the device in a safe, dry, clean environment.
Reduce residual risks by using the 2-in-1 Chainsaw with Telescopic Pole with
care and following all safety notes as well as other instructions.
WARNING: Before use, check whether your national regulations
restrict the use of the device.
13
To Next Page
Loading...