27
2-in-1 Chainsaw with Telescopic Pole
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: N
o
. 705156 · 03/2021 · GCS250F
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL: N
o
. 705156 · 03/2021 · GCS250F
• Use only the low-kickback chain and guide bar (7) that were supplied with this
chainsaw.
• Never use a dull or loose chain. Keep chain sharp with proper tension.
How to use saw safely
1. Use the chainsaw only with secure footing.
2. Hold the chainsaw at the right-hand side of your
body (Fig O).
3. The chain must be running at full speed before it
makes contact with the wood.
4. Use the bumper spikes (38) to secure the saw onto
the wood before starting to cut (Fig J).
5. Use the bumper spikes as a leverage point while
cutting.
6. Do not operate the chainsaw with arms fully
extended, attempt to saw areas which are dicult to
reach, or stand on a ladder while sawing (Fig P).
NOTE: Never use the chainsaw above shoulder
height.
Pole saw applications
WARNING: Do not use the pole saw if you are tired or under the
inuence of drugs, alcohol or medication.
WARNING: If you are unfamiliar with the following cutting
procedures, ensure you fully read and understand the instructions
before undertaking the task.
WARNING: is the oil reservoir lled? Check the oil level window
(13) (Fig. I) prior to starting and regularly during operation. Rell
oil when oil level is low. A full oil tank will last approximately 12
minutes of cutting depending on sawing intensity and stops.
WARNING: Check recently replaced chain tension about every 10
minutes during operation.
NOTE: For the safety of the operator, the shoulder strap (39) should always be
worn when using the pole saw.
Elbow
Locked
WARNING:
!
NEVER
REVERSE
HAND
POSITIONS
O
P
To Next Page
Loading...