ALDI HM80L - Disposal and Recycling; Troubleshooting

26
AFTER SALES SUPPORT
 support@scheppach.com.au
 1300 855 831
MODEL: HM80L PRODUCT CODE: 60120 04/2018
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Disposal and recycling/Troubleshooting HM80L
XIII. Disposal and recycling
The equipment is supplied in packaging to prevent it from being damaged in tran-
sit. The raw materials in this packaging can be reused or recycled. The equipment
and its accessories are made of various types of material, such as metal and
plastic. Defective components must be disposed of as special waste. Ask your
dealer or your local council.
XIV. Troubleshooting
Fault Possible cause Remedy
Motor does not
work
Motor, cable or plug de-
fective, fuses burnt
Arrange for inspection of the machine
by a specialist. Never repair the motor
yourself. Danger! Check fuses and
replace as necessary
The motor
starts up slowly
and does not
reach operating
speed.
Voltage too low, coils
damaged, capacitor burnt
Contact the utility provider to check
the voltage. Arrange for inspection
of the motor by a specialist. Arrange
for replacement of the capacitor by a
specialist
Motor makes
excessive
noise
Coils damaged, motor
defective
Arrange for inspection of the motor by
a specialist
The motor does
not reach its
full power.
Circuits in the network are
overloaded (lamps, other
motors, etc.)
Do not use any other equipment or
motors on the same circuit
Motor over-
heats easily.
Overloading of the motor,
insufcient cooling of the
motor
Avoid overloading the motor while
cutting, remove dust from the motor
in order to ensure optimal cooling of
the motor
Reduced
cutting power
when sawing
Saw blade too small
(ground too much)
Readjust end stop of the saw unit
Saw cut is
rough or wavy
Saw blade dull, tooth
shape not appropriate for
the material thickness
Resharpen saw blade and/or use
suitable saw blade
Workpiece
pulls away and/
or splinters
Excessive cutting pres-
sure and/or saw blade not
suitable for use
Insert suitable saw blade