12
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: HM80L PRODUCT CODE: 60120 04/2018
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Safety regulations HM80L
3 Protect yourself from electric shock
– Avoid physical contact with earthed parts (e.g. pipes, radiators, electric rang-
es, cooling units).
4 Keep children away
– Do not allow other persons to touch the equipment or cable, keep them away
from your work area.
5 Securely store unused electric tools
– Unused electric tools should be stored in a dry, elevated or closed location
out of the reach of children.
6 Do not overload your electric tool
– They work better and more safely in the specied output range.
7 Use the correct electric tool
– Do not use low-output electric tools for heavy work.
– Do not use the electric tool for purposes for which it is not intended. For ex-
ample, do not use handheld circular saws for the cutting of branches or logs.
– Do not use the electric tool to cut rewood.
8 Wear suitable clothing
– Do not wear wide clothing or jewellery, which can become entangled in mov-
ing parts.
– When working outdoors, anti-slip footwear is recommended.
– Tie long hair back in a hair net.
9 Use protective equipment
– Wear protective goggles.
– Wear a mask when carrying out dust-creating work.
10 Connect the dust extraction device if you will be processing wood, mate-
rials similar to wood, or plastics.
– If connections for dust extraction and a collecting device are present, make
sure that they are connected and used properly.
– When processing wood, materials similar to wood, and plastics, operation
in enclosed spaces is only permitted with the use of a suitable extraction
system.
11 Do not use the cable for purposes for which it is not intended
– Do not use the cable to pull the plug out of the outlet. Protect the cable from
heat, oil and sharp edges.
12 Secure the workpiece
– Use the clamping devices or a vice to hold the workpiece in place. In this
manner, it is held more securely than with your hand.
– An additional support is necessary for long workpieces (table, trestle, etc.) in
order to prevent the machine from tipping over.
– Always press the workpiece rmly against the working plate and stop in
order to prevent bouncing and twisting of the workpiece.
13 Avoid abnormal posture
– Make sure that you have secure footing and always maintain your balance.
To Next Page
Loading...
