00800 - 36 46 36 00
IRE
GB
8. Switch the shaver off once you have finished shaving.
9. Clean the shaver as described in the chapter “Daily
cleaning after a wet shave”.
Using the trimmer
Keep in mind that the trimmer always
generates a straight cutting edge. If you do
not want a straight cutting edge, you must
hold the shaver at an angle.
For hard-to-reach areas or for very precise
cuts, use a comb to check the hair you intend
to trim with the trimmer and the cut length.
Use the trimmer as follows:
1. Move the trimmer
13
all the way out until it audibly
locks into place (see fig. C).
2. Use the On/Off switch
5
to turn the shaver on.
3. Slowly guide the trimmer up to the hair you intend to
cut.
Always use short strokes to cut your hair.
4. Turn the shaver off.
5. Clean the shaver as described in the chapter “Daily
cleaning after a wet shave” or “Daily cleaning after a
dry shave”.
Using the travel guard
The shaver is equipped with a travel guard that prevents
the shaver from accidentally activating.
To Next Page
Loading...
