ALDI ViSage - Daily Cleaning after a Wet Shave

Cleaning and maintenance
AFTER SALES SUPPORT
www.aquarius-service.com
22
GB IRE
00800 - 36 46 36 00
IRE
GB
8. Firmly mount the shaver head on the shaver until the
locking mechanism audibly engages (see fig. E).
9. Place the protective cap
1
on the shaver.
The shaver is now ready for use again.
Daily cleaning after a wet shave
1. Use the On/Off switch
5
to turn off the shaver.
2. Before cleaning, pull the 5 V plug
8
out of the
shaver.
3. Hold the shaver over the sink.
4. Depress both release buttons
4
to release the
shaver head
2
(see fig. D).
5. Pull the shaver head up and off.
6. Wash the shaver head thoroughly under warm
running water on the inside and outside (see fig.F).
7. Carefully dry the shaver head with a lint-free cloth
or a paper towel. In the process, do not push the
shaving foils in.
8. Thoroughly rinse off the top part of the shaver and
the shaver blades under warm running water
(see fig.G).
9. Use the On/Off switch
5
to switch the shaver on
without the shaver head for approx. 5–10 seconds to
dispel any drops of water off of the shaver blades
3
.
10. Use a lint-free cloth or a paper towel to thoroughly
dry off the shaver.