00800 - 36 46 36 00
IRE
GB
11. Use the cleaning brush
7
to completely remove all
hair from the shaver blades and the entire top part of
the shaver (see fig.H).
12. Thoroughly rinse off the top part of the shaver and the
shaver blades under warm running water
(see fig.G).
13. Use the On/Off switch
5
to switch the shaver off
without the shaver head for approx. 5–10 seconds in
order to dispel water drops from the shaver blades
3
.
14. Use a lint-free cloth or a paper towel to thoroughly dry
off the shaver.
15. Firmly mount the shaver head on the shaver so that the
locking mechanism locks into place (see fig. E).
16. Place the protective cap
1
on the shaver.
The shaver is now ready for use again.
User maintenance for the shaving foils
To maintain the performance of your shaver and increase
the service life of the shaving foils, you should perform
user maintenance on the shaving foils every two months
as follows:
1. Put a drop of fine, non-resinous household oil on the
tip of your finger.
2. Distribute the oil evenly on the shaving foils of the
shaver head
2
.
3. Without applying pressure, dab the shaving foils with
a soft, lint-free cloth or paper towel.
To Next Page
Loading...
