Maintenance Instructions for the mini 13
Routine Testing
How to Clean the Devices
Changing Battery’s in the Companion
mini
It is recommended to test the system weekly by simulating spasm movements on the bed for 15 seconds
(the default time unless changed by a user via programming) & ensure the “Alarm” call is sent to the pager.
Routine Testing chart is provided on page 15.
It is also recommended to regularly clean the units by wiping with cotton wool pads moistened (compressed until
dripping stops) with a mild detergent (0.5% washing up liquid) solution or by using an alcohol or baby wipe. Avoid
getting any liquid into the micro-USB connector.
Remove the base of the monitor as per gure 3 above OR gure 7 & 8 below. Also please notice the polarity
marked into the case (Fig. 5) when replacing the 2x AAA batteries.
After changing the battery’s, the monitor MUST be turned on again by pressing the recessed TEST button and
waiting for the 60 second test mode to nish.
Figure 6Figure 5
To Next Page
Loading...
Need help?
General
