Companion mini Function 9
System Operation
Alarm Mode
You should now have the monitor installed in the bed, and the Connect-iT turned on and receiving the Safelink
®
signal every 8 seconds. Indicated by the red “Monitor” LED ashing on the Connect-iT ashing every 8 seconds.
If the pager stops receiving the failsafe radio signal from the monitor, the pager’s “Monitor” LED will be
permanently lit and an intermittent “Alarm” tone will sound.
If the monitor’s battery gets low the pager’s “Monitor” LED will ash every second, to indicate that you should now
change the battery in the monitor. (see page 10).
When prolonged movements are detected, the Alarm LED on the pager will light up, it will make an audible alarm
and will vibrate.
Pressing the Pair/Mute button will temporarily mute the alarm tone and stop the pager vibrating for 5 minutes.
A minute after the spasm activity has ceased, the pager will resume the alarm state, pressing the Pair/Mute button
again will clear the pager (If previously muted, this will be the second press).
SAFETY NOTICE:
The monitor is set to send an alarm signal
continuously (every 10 seconds) while spasm activity
continues. The monitor will send an “All clear” signal,
when atleast 1 minute has passed spasm free.
At this point the pager will continue to display an
“Alarm” LED, even after the “All clear” has been
received, up until the “Pair/Mute” button is pressed.
Always check the user even if the alarm
appears to have cleared.
To Next Page
Loading...
Need help?
General
