Alert-it Plesio Pager Handbook

Device Installation 6
The Companion mini monitor is shipped in a low-power
state. The monitor must be activated and placed into a
test mode by pressing the recessed “test” button on the
front of the monitor (Figure 1), typically using a pen tip.
The internal red light will ash to indicate the unit is now
turned on and in test mode. Once activated, it will enter a
60 second test mode which allows the user to easily test
the positioning of the monitor.
The mini will run for over a year in continuous use,
however if the companion mini is no longer needed it can
be turned off by press and holding the “test” button for
8 seconds. The red light will ash rapidly for 1 second
upon shutting down.
Turning on the Companion Mini (Monitor)
Turning off the Companion Mini (Monitor)
Figure 1
PLEASE NOTE:
After turning the companion mini off, any device
that it is paired with will now raise an “RF Fail”
alarm after 2 minutes. This is due to the devices
no longer receiving the 8 second Safelink signals
from the mini that they are expecting. To stop the
warning the mini will need to be unpaired from the
device or deactivated on the pager.

Alert-it Plesio Pager Specifications

General

Brand	Alert-it
Model	Plesio Pager
Category	Monitor
Language	English