Chapter 6: Editing Programs
78 S4 Plus Reference Manual
generator. You can patch the Mod Wheel somewhere else in addition to the Tracking
Generator, giving you gradual control of one function with the full range of the Mod
Wheel, while switching on a second function only at the top of the wheel.
However, the Tracking Generator interpolates between steps; this is sort of like
playing “connect the dots.” In other words, the Tracking Generator does not step
directly from one point to the next, but ramps from point to point.
Input
In Page 1 of the TRACK function, Quad Knob [1] selects the input of the Tracking
Generator:
• Note Number • Velocity • Release Velocity
• Aftertouch • Poly Pressure • Mod Wheel
• Pitch Wheel • MIDI Volume • Sustain Pedal
• Pedal 1 • Pedal 2 • PLFO
• FLFO • ALFO • PENV
• FENV • AENV • Random
• Trig Rate • Cont. A—D
For detailed descriptions of each of these sources, see the section “Modulation
Source” in the Mod section on pages 65 – 67.
Points 0 — 10 (00—100)
Quad Knobs [2], [3] and [4] in page 1 of the TRACK function control the levels of
points 0 —2. Points 3—6 are found on page 2, while points 7—10 are on page 3.
Name
The Name Function allows you to change the Program’s name. The Program name
can be up to 10 characters long. Use the PAGE [¨] and [Æ] buttons to position the
cursor. Quad Knob [1] selects the character. Here is a chart of available characters:
! " #$%&’ ( ) * +, - . / 0123
456789: ; <=>?@ABCDEFG
HI J KLMNOPQRSTUVWXYZ[
¥] ^_` abcdef ghi j kl mno
pqr st uvwxyz{| }ƨ
To Next Page
Loading...
