3
3. Safety precautions
Installation:
:
Operation
:
:
:
:
Maintenance:
:
:
:
:
:
:
All warnings in the manual are summarized on this
page.
"Mushrooms" = Fastening connections on the end
cap.
Pay special attention to the instructions below so that
severe personal injury or damage to the valve are
avoided.
Safety
- Always observe the technical data (see page
20).
- Always release compressed air after use.
- Never touch the coupling between the valve
body and the actuator if compressed air is sup-
plied to the actuator.
Always observe the technical data (see page 20).
Never touch the valve or the pipelines when pro-
cessing hot liquids or when sterilizing.
Never touch the coupling between the valve body
and the actuator if compressed air is supplied to
the actuator.
Always handle lye and acid with great care.
- Always observe the technical data (see page
20)
- Always release compressed air after use.
- The valve must never be hot when servicing it.
- The valve/actuator and the pipelines must never
be pressurised when servicing the valve/
actuator.
Never stick your fingers through the valve ports if
the valve is supplied with compressed air.
Never touch the coupling between the valve body
and the actuator if compressed air is supplied to
the actuator.
The actuator springs are not caged (ø85 mm,
NC/NO).
- Never use compressed air for removing the
end cap of the actuator.
- Always fit the end cap with the mushrooms
turned outwards and position it correctly be-
fore supplying compressed air to the actuator.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
