2 Safety
All warnings in the manual are summarized on this page.
Pay special attention to the instructions below so that severe personal injury and/or damage to the valve are avoided.
2.3 Safety precautions
Installation:
Always read the technical data thoroughly (see chapter 6.1 Technical data)
!
Always release compressed air after use
Never touch the clip assembly or the actuator piston rod if the actuator is supplied with compressed air
(see warning label)
Never stick your fingers through the valve ports if the actuator is supplied with compressed air
Operation:
Always read the technical data thoroughly (see chapter 6.1 Technical data)
Never touch the clip assembly or the actuator piston rod when the actuator is supplied with compressed
air (see warning label)
!
Never pressurise air connections (AC1, AC3) simultaneously as both valve plugs can be lifted (can cause mixing)
Never touch the valve or the pipelines when processing hot liquids or when sterilizing.
Never throttle the leakage outlet
Never throttle the CIP outlet, if supplied
Always handle lye and acid with great care
Maintenance:
Always read the technical data thoroughly (see chapter 6.1 Technical data)
!
Always fit the seals correctly
Always release compressed air after use
Always remove the CIP connections, if supplied, before service.
Never service the valve when it is hot
Never pressurise the valve/actuator when the valve is serviced
Never stick your fingers through the valve ports if the actuator is supplied with compressed air
Never touch the clip assembly or the actuator piston rod if the actuator is supplied with compressed air
(see warning label)
Always useAlfaLavalgenuinespareparts. ThewarrantyofAlfaLavalproductsisdependentontheuseof
Alfa Laval genuine spare parts.
Transportation:
Always ensure that compressed air are released
Always ensure that all connections is disconnected before attempting to remove the valve from the installation
Always drain liquid out of valves before transportation
Always used predesigned lifting points if defined
Always ensure sufficient fixing of the valve during transportation - if specially designed packaging material is available, it
must be used
7
To Next Page
Loading...
Need help?
General