Manual
TIMY3 - General
Page 22
10.3.2 BEEP
This switches the channel beep on or off.
• <OFF>
• <ON> Factory default
10.3.3 TED-RX
This activates the multichannel reception by the TED-RX.
• <OFF> Factory default
• <ON>
ATTENTION! If this function is activated the serial interface is occupied by the TED.
10.3.4 CHANNEL-PATTERN
This menu is currently not available. Certain channels can be activated or deactivated.
10.3.5 WTN Delay
This function is only activated when the internal WTN is deactivated; i. e. if an external WTN is
connected.
10.4 DISPLAY
This is for setting the TIMY3 display and scoreboard.
10.4.1 RUNNING TENTH
In the display and via interface the running time is issued in 1/10. Function not available for all
programs. Factory setting: OFF
10.4.2 DELAYTIME 1
The delay time determines for how long the intermediate times are shown on display and
scoreboard. The display time can be set e.g. for intermediate times of the running time in sec-
onds. Moreover, this time is also applied for the automatic start number continuation at the
finish. Factory default is 03 seconds.
10.4.3 DELAYTIME 2
This is for setting the display time for total time. Factory default is 03 seconds.
10.4.4 BACK LIGHT
This is to adjust the back light of the display. Factory default is <ENERGY SAVE>.
10.4.4.1 ENERGY SAVE
Backlight is switched on during external power supply, switched off during battery supply.
10.4.4.2 ON
Backlight is always switched on.
10.4.4.3 AUTOMATIC
Backlight is switched on for 5 seconds with each keystroke and timing impulse.
To Next Page
Loading...