Manual
TIMY3 - General
Page 26
10.9.3 SETTINGS
• <RADIO POWER> 10 (standard), 25, 50 100 mW
• <RS232> OFF, ON (standard)
• <EDGE> ↑ only rising, ↑+↓ rising and falling
• <WTN-UPDATE> OFF, ON (standard)
• <RF-UPDATE> ON, OFF (start with F0 and cancel with F1); at least one
participant must be connected
• <PULSE HOLD> showing channels with corresponding settings of dura-
tion, changes with keys up/down, OK and 0-9
• <STANDARD> settings are reset to standard settings
10.9.4 TEAM
Settings of the team (1-9 A-F) – siehe Bedienungsanleitung WTN
10.9.5 Error Messages
An old version was identified within the network.
A channel is constantly triggered, e.g. when a photocell is misaligned.
Check 0.1sec correction
The time correction for the channel was set to 0.0 and a delayed packet was received by ra-
dio.
10.10 KEYBOARD-LOCK
This is for activating the keypad lock in order to prevent accidental entries. All keys of the
TIMY3 are disabled. To enable the keyboard lock enter 1 2 3 4 5 6.
To Next Page
Loading...