ALGE-Timing Timy 3 - Interface Settings; Printer Settings

Manual
TIMY3 - General
Page 23
10.5 INTERFACE
Settings for the RS232 and scoreboard interface. Some settings are only available in certain
programs.
10.5.1 DISPLAYBOARD
These are settings for ALGE LED displays.
• <CONTRAST> adjusts the brightness (0 – 9) of the LED display board
• <TIME + DATE> internal time and date of scoreboard is synchronized
• <DISPLAY MODE> without function
• <BAUDRATE> standard is 2400, the baud rate of the TIMY3 and also of
the scoreboard is set
• <TIMEOUT> period after which the display switches to time of day
• <ADRESS> address for LED display board
• <SAFETY CAR> display mode permanent or flashing
• <LAPS> number of laps
• <CTD

LAP> manual or automatic
• <FORMAT> output of time of day or play time
10.5.2 RS232
These are settings of the RS232 of the TIMY3.
• <MODE>
• <BAUDRATE> standard is 9600
• <SENDE MEMORY> sends the memory contents of the TIMY3.
• <HANDSHAKE>
• <TRACK-MODE> norm or ident: change output format (program Track-
timer)
• <TIMY<->TIMY> communication between two TIMY3
10.5.3 GSM-MODEM
These are settings of the modem communication of the TIMY3.
• <ENTER NR> enter the number to dial
• <SEARCH MODEM > search a connected modem
• <PIN CODE> enter the SIM card pin code
• <STOP GSM-MODEM> disconnect the connection
• <MEMORY

SMS send the memory by SMS
10.6 PRINTER
This menu is for setting the printer parameters.
10.6.1 PRINTER-MODE
• <PRINTER OFF>
• <PRINTER ON > Standard
• <PAUSE> Printer stops and times will be saved. Times are printed
when printer is switched on again.
10.6.2 PRINT STARTTIME
• < OFF> Standard
• < ON >