70 | Operating the monitor
The OSD functions only in the normal operation mode. If you press the joystick
during the Standby mode, the following message will appear depending on the
selected input:
NOTE: The message may be slightly different according to the connected
input signal.
Activate the computer and wake up the
monitor to gain access to the OSD.
If DP 1, DP 2, or HDMI input is selected and the corresponding cable is not
connected, the following message will appear:
NOTE: The message may be slightly different according to the selected
input signal.
Activate the computer and wake up the
monitor to gain access to the OSD.
When Pixel Refresh is selected, the following message appears:
Once you select Ye
s, the monitor will be turned off and the refresh process will
To Next Page
Loading...
