ALLEN & HEATH iLive Series Reference Guide

iLive Reference Guide – Firmware Part 2 - 94 AP6526-2 iss.4
Connect to the iLive To launch the iLive Tweak application,
click on the icon on the iPhone home screen. Once launched you
can select an iLive MixRack from the list. Make sure the iLive is
powered on, the wireless router has been correctly configured and
the iPhone Wifi is connected to the correct network. Check that the
Wifi icon in the top left toolbar shows good signal strength.
Touch Connect, select a User, enter a password if one has been set
within the iLive for that User, and touch Login as shown below. After
a few seconds the iLive should connect and the Channel Select
screen shown.
Open iLive Tweak Available MixRacks
shown in list
Touch Connect to connect to
selected iLive MixRack
MixRack last connected to shown here.
If different then spin the drum to display
the rack you want to connect in the Unit
Name box.
Select a User, enter the Password
if one is set for that user, then
touch Login
If no password has been set
for the selected User then
ignore the Password box.
Touch Login to connect.
To exit the iLive Tweak application
press the iPhone Home button
The iPhone is connected.
Select the channel you want to
adjust using the Tweak
functions.

ALLEN & HEATH iLive Series Specifications

General

Sampling Rate	48kHz
Type	Digital Mixing System
Faders	Motorized
Ethernet Ports	Yes
Recallable Preamps	Yes
Built-in Rackmount Mixer	No
Weight	Varies by model
FX Engines	8
Remote Control	Yes, via Ethernet
Audio Networking	Dante
EQ	4-band parametric per channel
Dynamics	Compressor, gate on every channel
Effects	Reverb, Delay
Digital Connectivity	MADI
Control Surface Options	Various surface sizes available
Expandability	Yes
Compatibility	Compatible with iLive MixRacks and Surfaces