iLive Reference Guide – Firmware Part 2 - 27 AP6526-2 iss.4
GATE (Channel only)
The noise gate provides a full set of controls and
signal metering as you would find on a top grade
outboard processor. The side chain filter may be
switched in or out and self keyed or keyed from
another input (within an associated range of 8 DSP
channels). Use the controls or screen to set the
threshold (a signal meter displays under the control
to help you set this quickly), depth (how much the
gate attenuates), hold time (how long the gate
remains open after the signal drops below the
threshold), and dynamics. A screen histogram
displays the gate activity over time.
Note: The side chain can only be keyed by itself or
one of 8 channels in the same DSP block.
INSERT (Channel and Mix) new pic
A physical input and output socket may be
assigned as an insert send and return for a channel
if outboard processing is required. Configure this
by touching the top view INSERT box to open the
INSERT page. Select the sockets (devices) to use
for the send and return and the operating level
(+4dBu or -10dBV).
Note: In most cases it should not be necessary
to insert outboard processing. iLive features
plenty of high quality built-in processing on every
channel and mix output.
Note: Sockets assigned as inserts are not
available for use as channel or mix inputs or
outputs. To reuse the sockets first deassign the
associated inserts.
To Next Page
Loading...
Need help?
General
