iLive Reference Guide – Firmware Part 2 - 45 AP6526-2 iss.4
Using the COPY / PASTE /RESET edit keys
iLive provides a quick and intuitive edit function to copy or reset settings between channels, processing
blocks and mixes. This uses dedicated edit keys on the Surface rather than complex screen menus.
COPY / PASTE / RESET keys These functions are protected
from accidental operation. Pressing one of these keys by itself does
nothing. The edit function is actioned only if the key is first held down
and then a SEL or MIX key elsewhere on the surface is pressed while
it is held.
The lower toolbar of the TouchScreen displays information about the
edit operation, for example what is currently held on the clipboard, or
whether an action is valid or not.
You can copy or reset whole channels or selected blocks of
parameters, for example setting up all the processing for a vocal
channel as a starting point and then copying it to other vocal
channels. You can work with just one block of parameters, for
example to copy a Compressor across a range of instrument
channels.
You can copy or reset a whole mix or the mix parameters of just one
channel, for example as a starting point for several in-ear monitors.
Note: When using the edit keys make sure the TouchScreen is in
normal mixing mode, not in MIXRACK, SURFACE or
NAME&COLOUR mode. These modes take over the function of the
strip SEL keys.
3
4
1
2
Information
T-80 Surface
iLive-144 Surface
To Next Page
Loading...
Need help?
General
