Qu-16 User Guide 24 AP9031 iss.2
6.9 Working with the sends on faders:
Press a Mix key. The master strip presents the mix fader and
controls. The 16 channel faders move to present the sends to
that mix.
Move a channel fader to adjust its send level to the selected
mix.
Hold the Assign key to view the current channel assignments
to the mix. The Sel keys light when the channel is assigned
(routed) to the mix. To toggle the assignments on or off,
press channel Sel keys while holding Assign.
Hold the Pre Fade key to view the current channel pre/post
fade settings for the mix. The Sel keys light when set to Pre-
fade. To toggle pre or post, press the channel Sel keys while
holding Pre Fade. It is typical to use Pre-fade for monitor
sends and Post-fade for effects sends.
Press the Mix key again or press LR to return to the main
mix, or press another Mix key to adjust a different mix.
Note Always remember to return to the main LR mix once you
have finished adjusting monitor or effects levels.
6.10 Copy, Paste, Reset keys
Press + hold down one of these keys and then press
another key or screen item to copy, paste or reset the
related parameters. For example:
Copy – Press Copy + a channel Sel key to select its
processing to copy. Press Paste + another channel
Sel key to paste the processing to that channel.
You can copy just one processing block such as PEQ
using its In key and then paste it into other channels
using their strip Sel keys.
Reset – Press Reset + a channel Sel to instantly reset
its processing to factory default settings.
The following Copy/Reset is supported:
+ Input strip Sel key = HPF, Gate, PEQ, Comp, Delay
+ Mix strip Sel key = PEQ, GEQ, Comp, Delay
+ HPF In key = HPF only
+ PEQ In key = PEQ only
+ Gate In key = Gate only
+ Comp In key = Compressor only
+ touch Scene item in list = Scene contents
Sends on faders
Pre/Post
Assign
Copy parameters
Paste parameters
Reset parameters
To Next Page
Loading...
Need help?
General
