P–3 Preface
Publication 1203–5.1 –– July, 1997
This adapter is designed to be used with the following Allen-Bradley
programmable controllers:
• PLC-2/30
with SD2 (communications module version 1.02 or
later)
• PLC-3
• SLC 500t with 1747-SN scanner
• PLC-5/10t, PLC-5/15t, PLC-5/25t family
• PLC-5/30t, PLC-5/40t, PLC-5/40Lt, PLC-5/60t,
PLC-5/60Lt
family, PLC-5/80t
• PLC5/250t
• PLC
scanner modules and subscanners.
This adapter was tested with the current revision level of the PLC
processors listed. Earlier versions of the processors may not be
compatible.
The following terms and abbreviations are specific to this product.
For a complete listing of Allen–Bradley terminology, refer to the
Allen–Bradley Industrial Automation Glossary.
In this manual, we refer to the:
• remote I/O communications module as communications module
• variable frequency ac drive (1305, 1336 FORCE, or 1336 PLUS)
as the drive or SCANport device
• The programmable logic controller as the programmable
controller
• Allen–Bradley remote input/output network as remote I/O
• earth ground as Gnd
The following conventions are used throughout this manual:
• Bulleted lists provide information, not procedural steps.
• Numbered lists provide sequential steps or hierarchical
information.
• Italic type is used for emphasis and chapter names.
We also use this convention to call attention to helpful information.
PLC Product Compatibility
"
Terms and Abbreviations
Common Techniques Used in
this Manual
"
To Next Page
Loading...
Need help?
General
