1336 PLUS II Firmware Download Module 7
Transferring the File to the Drive
12. Press the Enter key on your computer once to signal the drive –
an introduction screen will be displayed.
13. Press “F” to enter the Flash Mode. You are now prompted to
confirm your choice “Are you sure?” (y or n).
Important:
During the time that the flash memory is being
upgraded,thedrivewillbeina“non-operationalstate”
and will not have the ability to control the motor. Be
certain that placing the drive in a non operational state
is acceptable.
Press “Y” to place the drive in flash mode (the Power LED on the
module will illuminate). Press “Enter” to continue.
Allen-Bradley Replacements
To Next Page
Loading...
