2–3Quick Start for Experienced Users
Publication
17476.6 - July 1996
4.
Insert the 1747SN module into the chassis.
Reference
ATTENTION: Never install, remove, or wire
modules with power applied to the chassis or
devices wired to the module.
!
(Chapter 3)
(Installation and
Wiring)
Make sure system power is off; then insert the scanner module into your 1746 chassis.
In this example procedure, local slot 1 is selected.
Card
Guide
Top and Bottom
Module Release(s)
5.
Connect
all RIO link devices.
Reference
Ensure that you:
•Daisy chain each RIO link device.
•Ground the shield drain wire to the nearest chassis mounting bolt.
•Connect the appropriate termination resistors on each end of the link.
(Chapter 3)
(Installation and
Wiring)
To Next Page
Loading...