Allen-Bradley 1747-SN - Page 36

2–4 Quick Start for Experienced Users
Publication 17476.6 - July 1996
6.
Configure the system.
Reference
Set up your system I/O configuration for the particular slot in which you installed the scanner (slot 1 in
this example). If using APS software, select the 1747 scanner from the list of modules. If it is not
listed in your software version, select Other and enter the scanner input module ID code (13608)
at the prompt on the I/O configuration display.
(Additional information about how to use AllenBradley's Advanced Programming Software [APS] to
configure your system can be found in the APS User Manual, Publication 9399APSUM.)
Example of Software Prompt:
Chapter 4
(Configuration and
Programming)
your
programming
software's user
manual
Press ENTER to select I/O Module
Enter Module ID Code> 13608
offline SLC 5/02 File EXAMPLE
F2
SELECT
MODULE
7.
Enter the number of scanned words.
Reference
Enter the number of Scanned Input and Output Words using the Specialty I/O and Advanced Setup
menus. The default value is 32 I/O words. You can specify less than 32 and reduce the processor
scan time by transferring only the part of the input and output image that your application requires. It
is important that you do not set either of these values to 0. If you do, the scanner will not work
correctly.
(Additional information about how to use AllenBradley's Advanced Programming Software [APS] to
configure your system can be found in the APS User Manual, Publication 9399APSUM.)
Chapter 4
(Configuration and
Programming)
your
programming
software's user
manual